How to Test and Pin-Point Coax Cable Signal Leakage with Pressure Testing
Learn > Coax Network Testing Tools > How to Test and Pin-Point Coax Cable Signal Leakage with Pressure Testing

Cable signal leakage often happens when there are loose fittings, broken cables, or poorly connected fittings. When it happens, the source must be detected and contained.

Detecting signal leakage at the cable plant is easier since signal levels are much higher than in subscribers’ homes. This is where the pressure test comes into play. A pressure test for signal leakage is similar to a pressure test for air leakage: the increased pressure allows you to detect minor weaknesses that would be otherwise undetectable at standard pressures.

 

Pressure Testing with the Right Tools

The basic principles for signal leakage ingress and egress testing is the same. The first step to pressure testing is making sure you have the proper equipment and that your equipment is calibrated to ensure accurate measurements at the plant or subscriber homes.

Signal leakage pressure testing requires routine monitoring at the plant and subscriber homes. Inside end users’ homes, technicians need high sensitivity equipment because the signal levels are lower than plant levels.

A visual example is like trying to locate a leak in a car tire. If it is too small, you may not hear the air leaking and you certainly won’t see it. But by placing soapy water over the tire and applying pressure, you will see bubbles wherever the point of leaking occurs.

With the proper equipment, this same basic concept can be employed for in-home signal leakage testing. Technicians can apply pressure to pinpoint even the smallest of leaks and secure it, before they leave the customer’s home.

 

Pin-Point Leakage to the Exact Nail or Outlet

Hitron’s CSN-01 is a signal meter that induces signal to the home cabling to detect signals emanating from the cable plant. It pin-points leaks with precision, detecting the exact nail or outlet that is causing issues. The CSN-01 communicates its results to Hitron’s MyMeter app which also controls the CGN-DP3 wireless hand-held DOCSIS 3.1 meter. These tools are a comprehensive solution that make the job quick, easy and seamless for operators and technicians.

Are you looking for a cost-effective and efficient way to empower your technicians to troubleshoot the Whole Home?

This comprehensive combination of tools will provide you with the intelligence and unsurpassed usability, giving you complete Whole Home Certification testing at a fraction of the cost of other solutions.

Learn More about Coax Network Testing Tools

Signal Attenuation Explained and How to Prevent It

Signal attenuation in networking means signal loss. It is the weakening or loss of signal strength during transmission. This is a natural consequence of signal transmission over long distances. The farther a signal wavelength travels, the smaller the amplitude...

Detect and Defeat Signal Leakage with One Simple Test

Cable signal leakage is an open invitation to cause disruption for customers and operators alike. For customers, signal leakage can cause negative experiences with online and voice services, poor picture quality and image freezing. This will undoubtedly lead to...

How Pressure Testing Can Reduce Your Operational Costs

Understanding the cause of cable signal leakage and how to prevent it can be critical for reducing operational costs. Mostly, this is because the FCC issue fines for interferences. The more severe the interference, like interfering aeronautical communication and LTE,...

What is a Spectrum Analyzer and How Can it Eliminate Signal Leakage?

A spectrum analyzer is a testing tool that measures and displays the amplitude versus frequency for input signals. The terms “spectrum analyzer” and “signal analyzer” are used almost interchangeably. But there are some slight differences. Spectrum analyzers are...

Avoid Signal Insertion Loss by Proactively Detecting It

Insertion loss can be defined as the attenuation of the signal as it passes through a passive device. The attenuation is caused by the passive device. The type of passive device determines the amount of attenuation it has on the signal. For example, as a signal...

Related Articles